![methoding magmasoft methoding magmasoft](https://0.academia-photos.com/attachment_thumbnails/53699535/mini_magick20190119-27254-kllqor.png)
The right first time capability also shortens product development lead time.
Methoding magmasoft software#
The second rosette was in a region of steep stress gradient, which resulted in a difference of up to 40%, ~40 MPa between the simulation and instrumentation results. Another software package called MAGMAsoft, which simulates the flow and solidification of melt, is employed to determine the castability of a particular product so that it turns out right the first time, and is done so at the lowest possible cost. Hot tearing is one of the main defect sources in steel castings. The von Mises stress from the simulation model correlated well with the findings from the instrumentation trial, showing a difference of 5.5%, ~ 10 MPa for one strain gauge rosette located in an area of low stress gradient. Optimization of Steel Casting Design and Methoding. The strains were measured during the casting cycle, from which the von Mises stress was determined and then compared to the simulation model.
Methoding magmasoft trial#
Factors such as additional loading from die closure force or metal injection pressure which are not modelled by Magmasoft® were seen to have very little influence on the stress in the die, less than 7%.ĪB - A strain gauge instrumentation trial on a high pressure die casting ‘HPDC’ die was compared to a corresponding simulation model using Magmasoft® casting simulation software at two strain gauge rosette locations. The second rosette was in a region of steep stress gradient, which resulted in a difference of up to 40%, ~40 MPa between the simulation and instrumentation results.
![methoding magmasoft methoding magmasoft](https://www.magmasoft.com.sg/export/shared/.galleries/solutions/Steel_c-pic10_800x400.jpg)
The von Mises stress from the simulation model correlated well with the findings from the instrumentation trial, showing a difference of 5.5%, ~ 10 MPa for one strain gauge rosette located in an area of low stress gradient. have used MAGMA soft to study the hot tearing and residual stresses in. N2 - A strain gauge instrumentation trial on a high pressure die casting ‘HPDC’ die was compared to a corresponding simulation model using Magmasoft® casting simulation software at two strain gauge rosette locations. two industrial component produced by four-cavity HPDC method 28. T1 - Stress correlation between instrumentation and simulation analysis of the die for high pressure die casting Stabilized finite element method for flows with multiple reference frames. Abstract = "A strain gauge instrumentation trial on a high pressure die casting were seen to have very little influence on the stress in the die, less than 7%.",